| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Any Juniper Networks SRX series device with one or more ALGs enabled may experience a flowd crash when traffic is processed by the Sun/MS-RPC ALGs. This vulnerability in the Sun/MS-RPC ALG services component of Junos OS allows an attacker to cause a repeated denial of service against the target. Repeated traffic in a cluster may cause repeated flip-flop failure operations or full failure to the flowd daemon halting traffic on all nodes. Only IPv6 traffic is affected by this issue. IPv4 traffic is unaffected. This issues is not seen with to-host traffic. This issue has no relation with HA services themselves, only the ALG service. No other Juniper Networks products or platforms are affected by this issue. Affected releases are Juniper Networks Junos OS 12.1X46 prior to 12.1X46-D55 on SRX; 12.1X47 prior to 12.1X47-D45 on SRX; 12.3X48 prior to 12.3X48-D32, 12.3X48-D35 on SRX; 15.1X49 prior to 15.1X49-D60 on SRX. |
| On all vSRX and SRX Series devices, when the DHCP or DHCP relay is configured, specially crafted packet might cause the flowd process to crash, halting or interrupting traffic from flowing through the device(s). Repeated crashes of the flowd process may constitute an extended denial of service condition for the device(s). If the device is configured in high-availability, the RG1+ (data-plane) will fail-over to the secondary node. If the device is configured in stand-alone, there will be temporary traffic interruption until the flowd process is restored automatically. Sustained crafted packets may cause the secondary failover node to fail back, or fail completely, potentially halting flowd on both nodes of the cluster or causing flip-flop failovers to occur. No other Juniper Networks products or platforms are affected by this issue. Affected releases are Juniper Networks Junos OS 12.1X46 prior to 12.1X46-D67 on vSRX or SRX Series; 12.3X48 prior to 12.3X48-D50 on vSRX or SRX Series; 15.1X49 prior to 15.1X49-D91, 15.1X49-D100 on vSRX or SRX Series. |
| Juniper Junos 11.4 before 11.4R12, 12.1X44 before 12.1X44-D32, 12.1X45 before 12.1X45-D25, 12.1X46 before 12.1X46-D20, and 12.1X47 before 12.1X47-D10 on SRX Series devices, when NAT protocol translation from IPv4 to IPv6 is enabled, allows remote attackers to cause a denial of service (flowd hang or crash) via a crafted packet. |
| Juniper Junos 12.1X46 before 12.1X46-D20 and 12.1X47 before 12.1X47-D10 on SRX Series devices allows remote attackers to cause a denial of service (flowd crash) via a crafted SIP packet. |
| named in ISC BIND 9.x before 9.9.8-P4 and 9.10.x before 9.10.3-P4 allows remote attackers to cause a denial of service (assertion failure and daemon exit) via a crafted signature record for a DNAME record, related to db.c and resolver.c. |
| Embedthis Appweb before 4.6.6 and 5.x before 5.2.1 allows remote attackers to cause a denial of service (NULL pointer dereference) via a Range header with an empty value, as demonstrated by "Range: x=,". |
| The SRX Network Security Daemon (nsd) in Juniper SRX Series services gateways with Junos 12.1X44 before 12.1X44-D50, 12.1X46 before 12.1X46-D35, 12.1X47 before 12.1X47-D25, and 12.3X48 before 12.3X48-D15 allows remote DNS servers to cause a denial of service (crash) via a crafted DNS response. |
| Cross-site scripting (XSS) vulnerability in the Dynamic VPN in Juniper Junos 12.1X44 before 12.1X44-D45, 12.1X46 before 12.1X46-D30, 12.1X47 before 12.1X47-D20, and 12.3X48 before 12.3X48-D10 on SRX series devices allows remote attackers to inject arbitrary web script or HTML via unspecified vectors. |
| Juniper Junos 12.1X44 before 12.1X44-D45, 12.1X46 before 12.1X46-D30, 12.1X47 before 12.1X47-D15, and 12.3X48 before 12.3X48-D10 on SRX series devices does not properly enforce the log-out-on-disconnect feature when configured in the [system port console] stanza, which allows physically proximate attackers to reconnect to the console port and gain administrative access by leveraging access to the device. |
| The Juniper SRX Series devices with Junos 11.4 before 11.4R12-S4, 12.1X44 before 12.1X44-D40, 12.1X45 before 12.1X45-D30, 12.1X46 before 12.1X46-D25, and 12.1X47 before 12.1X47-D10, when an Application Layer Gateway (ALG) is enabled, allows remote attackers to cause a denial of service (flowd crash) via a crafted packet. |
| Juniper Junos 11.4 before 11.4R8, 12.1 before 12.1R5, 12.1X44 before 12.1X44-D20, 12.1X45 before 12.1X45-D15, 12.1X46 before 12.1X46-D10, and 12.1X47 before 12.1X47-D10 on SRX Series devices, allows remote attackers to cause a denial of service (flowd crash) via a malformed packet, related to translating IPv6 to IPv4. |
| named in ISC BIND 9.x before 9.9.8-P4 and 9.10.x before 9.10.3-P4 does not properly handle DNAME records when parsing fetch reply messages, which allows remote attackers to cause a denial of service (assertion failure and daemon exit) via a malformed packet to the rndc (aka control channel) interface, related to alist.c and sexpr.c. |
| An Improper Check for Unusual or Exceptional Conditions vulnerability in the Packet Forwarding Engine (pfe) of Juniper Networks Junos OS on SRX Series, and MX Series with SPC3 allows an unauthenticated, network-based attacker to cause a Denial-of-Service (DoS).
When an affected device receives specific valid TCP traffic, the pfe crashes and restarts leading to a momentary but complete service outage.
This issue affects Junos OS:
21.2 releases from 21.2R3-S5 before 21.2R3-S6.
This issue does not affect earlier or later releases. |
| A Missing Authentication for Critical Function vulnerability in the Packet Forwarding Engine (pfe) of Juniper Networks Junos OS on MX Series with SPC3, and SRX Series allows an unauthenticated network-based attacker to cause limited impact to the integrity or availability of the device.
If a device is configured with IPsec authentication algorithm hmac-sha-384 or hmac-sha-512, tunnels are established normally but for traffic traversing the tunnel no authentication information is sent with the encrypted data on egress, and no authentication information is expected on ingress. So if the peer is an unaffected device transit traffic is going to fail in both directions. If the peer is an also affected device transit traffic works, but without authentication, and configuration and CLI operational commands indicate authentication is performed.
This issue affects Junos OS:
* All versions before 20.4R3-S7,
* 21.1 versions before 21.1R3,
* 21.2 versions before 21.2R2-S1, 21.2R3,
* 21.3 versions before 21.3R1-S2, 21.3R2. |
| Juniper Junos before 10.4 before 10.4R16, 11.4 before 11.4R8, 12.1R before 12.1R7, 12.1X44 before 12.1X44-D20, and 12.1X45 before 12.1X45-D10 on SRX Series service gateways, when used as a UAC enforcer and captive portal is enabled, allows remote attackers to cause a denial of service (flowd crash) via a crafted HTTP message. |
| Juniper Junos 10.4S before 10.4S15, 10.4R before 10.4R16, 11.4 before 11.4R9, and 12.1R before 12.1R7 on SRX Series service gateways allows remote attackers to cause a denial of service (flowd crash) via a crafted IP packet. |
| An Incorrect Calculation of Buffer Size vulnerability in Juniper Networks Junos OS SRX 5000 Series devices using SPC2 line cards while ALGs are enabled allows an attacker sending specific crafted packets to cause a transit traffic Denial of Service (DoS).
Continued receipt and processing of these specific packets will sustain the Denial of Service condition.
This issue affects:
Juniper Networks Junos OS SRX 5000 Series with SPC2 with ALGs enabled.
* All versions earlier than 21.2R3-S7;
* 21.4 versions earlier than 21.4R3-S6;
* 22.1 versions earlier than 22.1R3-S5;
* 22.2 versions earlier than 22.2R3-S3;
* 22.3 versions earlier than 22.3R3-S2;
* 22.4 versions earlier than 22.4R3;
* 23.2 versions earlier than 23.2R2. |
| A Missing Release of Memory after Effective Lifetime vulnerability in the IKE daemon (iked) of Juniper Networks Junos OS on MX Series with SPC3, and SRX Series allows an administratively adjacent attacker which is able to successfully establish IPsec tunnels to cause a Denial of Service (DoS).
If specific values for the IPsec parameters local-ip, remote-ip, remote ike-id, and traffic selectors are sent from the peer, a memory leak occurs during every IPsec SA rekey which is carried out with a specific message sequence. This will eventually result in an iked process crash and restart.
The iked process memory consumption can be checked using the below command:
user@host> show system processes extensive | grep iked
PID USERNAME PRI NICE SIZE RES STATE C TIME WCPU COMMAND
56903 root 31 0 4016M 2543M CPU0 0 2:10 10.50% iked
This issue affects Juniper Networks Junos OS:
* All versions earlier than 20.4R3-S9;
* 21.2 versions earlier than 21.2R3-S7;
* 21.3 versions earlier than 21.3R3-S5;
* 21.4 versions earlier than 21.4R3-S4;
* 22.1 versions earlier than 22.1R3-S3;
* 22.2 versions earlier than 22.2R3-S2;
* 22.3 versions earlier than 22.3R3;
* 22.4 versions earlier than 22.4R3;
* 23.2 versions earlier than 23.2R1-S2, 23.2R2. |
| An Improper Check for Unusual or Exceptional Conditions vulnerability in the flow daemon (flowd) of Juniper Networks Junos OS on
SRX4600 and SRX5000 Series
allows an attacker to send TCP packets with
SYN/FIN or SYN/RST
flags, bypassing the expected blocking of these packets.
A TCP packet with SYN/FIN or SYN/RST should be dropped in flowd. However, when no-syn-check and Express Path are enabled, these TCP packets are unexpectedly transferred to the downstream network.
This issue affects Junos OS on SRX4600 and SRX5000 Series:
* All versions before 21.2R3-S8,
* from 21.4 before 21.4R3-S7,
* from 22.1 before 22.1R3-S6,
* from 22.2 before 22.2R3-S4,
* from 22.3 before 22.3R3-S3,
* from 22.4 before 22.4R3-S2,
* from 23.2 before 23.2R2,
* from 23.4 before 23.4R1-S1, 23.4R2. |
| A Buffer Overflow vulnerability in SIP ALG of Juniper Networks Junos OS allows a network-based, unauthenticated attacker to cause a Denial of Service (DoS). On all MX Series and SRX Series platform with SIP ALG enabled, when a malformed SIP packet is received, the flow processing daemon (flowd) will crash and restart. This issue affects: Juniper Networks Junos OS on MX Series and SRX Series 20.4 versions prior to 20.4R3-S5; 21.1 versions prior to 21.1R3-S4; 21.2 versions prior to 21.2R3-S2; 21.3 versions prior to 21.3R3-S1; 21.4 versions prior to 21.4R3; 22.1 versions prior to 22.1R1-S2, 22.1R2; 22.2 versions prior to 22.2R1-S1, 22.2R2. This issue does not affect Juniper Networks Junos OS versions prior to 20.4R1 on SRX Series. |
